New Brunswick Alt/Ren Energy & Ethics/Regulatory 30 PDH Discount Package

This online engineering PDH course presents the fundamental principles behind the workings of a solar PV system, use of different components in a system, methodology of sizing these components and how these can be applied to building integrated systems. It includes detailed technical information and basic step-by-step methodology for design and sizing of off-grid solar PV systems.

The sun delivers its energy in two main forms: heat and light. There are two main types of solar power systems, namely, solar thermal systems that trap heat to warm up water and solar PV systems that convert sunlight directly into electricity (the latter being the focus of this course). Direct or diffuse light (usually sunlight) shining on the solar cells induces the photovoltaic effect, generating DC electric power. This DC power can be used, stored in a battery system, or fed into an inverter that converts DC into alternating current “AC”, so that it can feed into one of the building’s AC distribution boards (“ACDB”) without affecting the quality of power supply.

Several factors and aspects are taken into consideration when designing a solar PV system which will be discussed in this course.

This online engineering PDH course provides information on wind energy and wind turbines, and discusses the operating principles of wind turbines, their key components, technology and performance features, as well as cost economics and various environmental and social aspects.

The rising concerns over climate change, environmental pollution, and energy security resulted in an increased interest in developing renewable energy, with wind energy being at the forefront.

Wind energy refers to the technology that converts the motion of air into mechanical energy, usually for electricity production. The mechanism used to convert air motion into electricity is referred to as a turbine. A turbine is a large structure with several spinning blades connected to a rotor, where an electromagnetic generator generates electricity as wind causes the blades to spin.

This online engineering PDH course presents a performance analysis of 75 solar photovoltaic (PV) systems installed at federal sites, conducted by the Federal Energy Management Program (FEMP) with support from National Renewable Energy Laboratory and Lawrence Berkeley National Laboratory.

System data is analyzed for key performance indicators including availability, performance ratio, and energy ratio by comparing the measured production data to modeled production data. The analysis utilizes the National Renewable Energy Laboratory’s System Advisor Model (SAM), which combines a description of the system (such as inverter capacity, temperature derating, and balance-of-system efficiency) with environmental parameters (coincident solar and temperature data) to calculate predicted performance.

The measured performance metrics are useful in that they provide realistic expectations of performance, and owners of existing systems may compare their own measured performance values to the average and focus on corrective actions.

This online engineering PDH course discusses advantages to the electric grid that are gained through using electricity storage systems to supplement electrical generation systems. It presents a total of fourteen such advantages provided by an electricity storage capability, including ancillary services, grid system services and functional uses, end user/utility customer functional services, and renewables integration.

One example of an advantage is time-shifting, the purchase of electric energy when prices are low, and then storing it and using or selling the energy later when prices are high. Another example, possible only under certain grid conditions, is using energy storage to reduce the need to buy new central station generating capacity. A third example is using energy storage for grid regulation, that is, the damping of momentary differences caused by fluctuations in generation and loads. In general, the rapid-response characteristic (i.e., fast ramp rate) of most storage systems makes them especially valuable as a regulation resource.

This 2 PDH online course is intended for electric systems engineers/planners, storage system vendors, and regulators concerned with the design and implementation of stationary energy storage systems.

This online engineering PDH course provides an overview of biodiesel blends, the advantages of using biodiesel, precautions for use of biodiesel during cold weather, and the proper procedures for handling and use of biodiesel. This course also provides detailed information on biodiesel testing requirements and compatibility issues.

Biodiesel is a diesel replacement fuel for use in diesel engines. It is manufactured from plant oils, animal fats, and recycled cooking oils, is most commonly used as a blend with petroleum diesel in compression-ignition engines. Some of the advantages of Biodiesel are that it is renewable, can reduce greenhouse gases, compatible with new technology diesel engines, nontoxic, biodegradable, and suitable for sensitive environments. 

This online engineering PDH course presents a methodology to identify suitable sites for the establishment of renewable energy (RE) facilities intended to support critical infrastructure in an emergency.

"RE-Powering Critical Infrastructure" presents a methodology for identifying sites—typically formerly contaminated lands, closed landfills, and mine sites—close to critical infrastructure. If a renewable energy facility were to be installed at the site, then in the event of a natural disaster disrupting the national electrical grid, the RE at the site could provide emergency back-up for the critical infrastructure. The course applies this methodology to critical infrastructure including wastewater treatement plants, drinking water treatment plants, hospitals, schools, emergency centers, cell towers, fire stations, and natural gas distribution centers.

This online engineering PDH course provides basic information about small wind electric systems to help you decide if wind energy will work for you. 

Wind is created by the unequal heating of the Earth's surface by the sun. Wind turbines convert the kinetic energy in wind into mechanical power that runs a generator to produce clean electricity.

Can I use wind energy to power my home? More people across the country are asking this question as they look for a hedge against increasing electricity rates and a way to harvest their local wind resources. Although wind turbines large enough to provide a significant portion of the electricity needed by the average U.S. home generally require 1 acre of property or more, approximately 19.3% of the U.S. population lives in rural areas and may own land parcels large enough to accommodate a wind energy system.

This online engineering PDH ethics course presents the principles of engineering ethics and statutes for New Brunswick Professional Engineers.

Engineering has a direct and vital impact on the quality of life for all people, which is why it is important for engineers to put the interests and safety of the public ahead of their own, and maintain honesty and integrity at all times. Accordingly, several guidelines were established to help engineers conduct themselves ethically in their line of duty.

This course will address the code of ethics that every engineer is expected to live by when practicing their profession. This course also provides an overview of APEGNB’s general statutes and regulatory laws. It will also present unique and randomly selected ethical studies to demonstrate ethical challenges for professional engineers and alternatives to address these challenges.